Last modified by Leon Poon on 2021/07/16 18:40
From version 23.1
edited by Leon Poon
on 2020/05/31 14:26
Change comment: There is no comment for this version
To version 25.1
edited by Leon Poon
on 2020/05/31 14:44
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -13,15 +13,15 @@
13 13  
14 14  If your router currently has stock Linksys firmware:
15 15  
16 -1. Flash the "squashfs-factory.img" via Linksys UI, Wait for it to start to reboot.
16 +1. Flash the "squashfs-factory.img" via Linksys UI. Wait for it to start to reboot.
17 17  1. Configure your computer to have ip in 192.168.1.0/24 subnet but NOT 192.168.1.1. (so, use 192.168.1.2.) Start ping to 192.168.1.1.
18 -1. Cross your fingers that the router boots openwrt. Otherwise keep rebooting until it loads the openwrt partition. (Usually 3 times max.) Wait a few minutes from reboot to let it load. If you get response from ping 192.168.1.1 it means openwrt loaded.
18 +1. Cross your fingers that the router boots openwrt. Otherwise keep rebooting until it loads the openwrt partition. (Usually 3 times max.) Wait a few minutes from reboot to let it load. If you get ping response from 192.168.1.1 it means openwrt loaded.
19 19  1. Scp the "squashfs-sysupgrade.bin" into /tmp in the router. root@192.168.1.1. No password.
20 -1. Log in as root via SSH into shell. No password
20 +1. Log in as root via SSH into shell. No password.
21 21  1. Sysupgrade the uploaded squashfs-sysupgrade.bin. This should flash the openwrt firmware into both firmware partitions. It auto reboots.
22 22  1. opkg update
23 23  1. opkg install luci
24 -1. Access LuCI via 192.168.1.1. You can now configure.
24 +1. Access LuCI via http:~/~/192.168.1.1/. You can now configure.
25 25  
26 26  If you are on my 18.x below, sysupgrade will not work. You have to manually mtd write the 19.07 "kernel-initramfs.bin" into the nand and boot/log into it (192.168.1.1), then sysupgrade.
27 27