Last modified by Leon Poon on 2021/07/16 18:40
From version 41.1
edited by Leon Poon
on 2020/12/10 08:50
Change comment: There is no comment for this version
To version 40.1
edited by Leon Poon
on 2020/12/10 08:46
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -21,12 +21,8 @@
21 21  
22 22  If you are on my 18.x below, sysupgrading to a 19.07 image will not work. You have to manually mtd write the 19.07 "kernel-initramfs.bin" into the nand and boot/log into it (192.168.1.1), then sysupgrade.
23 23  
24 -Sysupgrade from 19.07.x to another 19.07.y will work. You can also upgrade via LuCI.
24 +Sysupgrade from 19.07.x to another 19.07.y will work. You can also upgrade via LuCI. **HOWEVER: **upgrading will wipe entire firmware partitions! Backup your files/config before sysupgrade.
25 25  
26 -{{warning}}
27 -Upgrading images will wipe entire firmware partitions! Backup your files/config before sysupgrade. It will reset router ip to 192.168.1.1.
28 -{{/warning}}
29 -
30 30  --**Images do not contain LuCi! (The build process doesn't include it for some reason I have not yet time to figure out.)** You need to have the **squashfs-sysupgrade.bin** flashed, then install LuCI. (See instructions below.)--
31 31  
32 32  --The EA8100 contains 2 firmware partitions. Using the Linksys UI will flash openwrt into only one of the 2 partitions. The booting process switches partition every few boots, so if you want to always boot into openwrt then you have to flash openwrt into both partitions.--