Tasmota
Last modified by Leon Poon on 2022/10/21 05:23
Things to run after flashing:
https://tasmota.github.io/docs/Commands/
| SaveData | 0 = save parameter changes only manually, e.g. with Restart 1 |
| NtpServer<x> | NTP server setup (x= 1..3) 0 = clear NtpServer<x> settings 1 = reset NtpServer<x> settings to firmware defaults <value> = set NtpServer<x> host or IP address (32 char limit) |
| Timezone | -13..+13 = set timezone offset from UTC in hours -13:00..+13:00 = set timezone offset from UTC in hours and minutes 99 = use timezone configured with TimeDst and TimeStd |
| PowerOnState | Control power state when the device is powered up. More information 0 / OFF = keep power(s) OFF after power up 1 / ON = turn power(s) ON after power up 2 / TOGGLE = toggle power(s) from last saved state 3 = switch power(s) to their last saved state (default) 4 = turn power(s) ON and disable further power control 5 = after a PulseTime period turn power(s) ON (acts as inverted PulseTime mode) |
| Restart | 1 = restart device with configuration saved to flash |
Wifi configuration: hostname
Mqtt configuration...
ESP32 (DevKitC) pins:
IO GPIO0
TX GPIO1
IO GPIO2
RX GPIO3
IO GPIO4
IO GPIO5
FL GPIO9
FL GPIO10
IO GPIO12
IO GPIO13
IO GPIO14
IO GPIO15
IO GPIO16
IO GPIO17
IO GPIO18
IO GPIO19
IO GPIO21
IO GPIO22
IO GPIO23
IO GPIO25
IO GPIO26
IO GPIO27
AO GPIO32
AO GPIO33
IA GPIO34
IA GPIO35
IA GPIO36
IA GPIO39