Things to run after flashing:
https://tasmota.github.io/docs/Commands/
| SaveData | 0 = save parameter changes only manually, e.g. with Restart 1 |
| NtpServer<x> | NTP server setup (x= 1..3) 0 = clear NtpServer<x> settings 1 = reset NtpServer<x> settings to firmware defaults <value> = set NtpServer<x> host or IP address (32 char limit) |
| Timezone | -13..+13 = set timezone offset from UTC in hours -13:00..+13:00 = set timezone offset from UTC in hours and minutes 99 = use timezone configured with TimeDst and TimeStd |
| PowerOnState | Control power state when the device is powered up. More information 0 / OFF = keep power(s) OFF after power up 1 / ON = turn power(s) ON after power up 2 / TOGGLE = toggle power(s) from last saved state 3 = switch power(s) to their last saved state (default) 4 = turn power(s) ON and disable further power control 5 = after a PulseTime period turn power(s) ON (acts as inverted PulseTime mode) |
| Restart | 1 = restart device with configuration saved to flash |
Wifi configuration: hostname
Mqtt configuration...